Oliver 619-16A, Руководство пользователя по эксплуатации и инструкция

Страница: 15 / 38

0619S20049 4-5
Removing The Motor (Continued)
•
Remove the terminal cover on the motor and disconnect the wiring, remember to
note the wire locations to ease replacement of the motor.
•
The motor should now be free and can be removed by sliding the motor out and
lifting it free of the machine.
•
Re-assemble by reversing the above steps.
Changing The Pump Or Coupling
•
Remove the rear cover and the “Motor Side” panel.
•
Loosen the intake hose at the pump; make sure you have something available to
catch the hydraulic oil leaking from the end of the hose when it is disconnected.
•
Remove the high-pressure hose from the outlet side of the pump.
•
Remove the four bolts from the feet of the motor which secure it to the shock
mounts, this will allow the motor to be pivoted slightly to allow pump removal.
•
Remove the bolts securing the pump to the bracket, pivot the motor and slide the
pump with its half of the coupling out and free of the motor.
•
Replace the pump by reversing the above procedures.
Replacing The Control Valve
•
Remove the front and side panels from the divider.
•
Disconnect the four high-pressure hoses and remove the filter head assembly from
the machine.
•
Remove the lower pivot bolt from the lower end of the linkage connecting the valve
and the control handle.
•
Remove the three screws holding the valve to the valve mounting plate and remove
the valve from the divider.
•
Remove the remaining linkage parts from the old valve and re-install them on the
new valve. The new valve can then be installed in the divider by reversing the above
procedures.