Olimpia splendid ALYAS E INVERTER 9, Инструкция по эксплуатации и техническому обслуживанию

Страница: 54 / 316

EN - 12
ENGLISH
2.5.4 - Drain pipe connection (figure 9)
a
. Insert the drain pipe (A), making sure that it slopes downwards.
b
. If necessary, connect an extension (C) to the drain pipe, isolate the joint with a protection pipe (B).
Tightly wind the connection point with a Teflon tape so as to ensure good tightness and im -
pede possible leakage. The part of the drain pipe which remains inside shall be wrapped in a
foam rubber sleeve to impede the formation of condensation.
c
. Remove the air filter and pour a small quantity of water inside the drain tray to check that water flows out
correctly from the unit.
2.5.5 - Piping and protection wrapping connection (figure 10)
Evenly wrap the connection cable, drain pipe and electric cables with electrical tape, as illustrated in figure 10.
Given that the condensate water from the rear of the indoor water is collected in the “Pond Box”
tray and taken out of the compartment, do not put anything in the tray.
Key (figure 10)
2.6 - SELECTION OF POSITION FOR OUTSIDE UNIT
To obtain the best operating performance and prevent faults or hazardous conditions, the position of outdoor
unit installation must meet the following requirements:
a
. It should be protected from direct sunlight (fig. 11).
b
. It should be protected from atmospheric agents (rain, snow) and from direct gusts of strong wind (fig. 11).
c
. It should also be protected from any copious downflow of water (gutter drains or watering cans)
(fig. 12).
d
. It should stand on a solid surface able to withstand its weight (fig. 12).
e
. The outside unit must be installed perfectly level (check with a bubble level).
If the outdoor unit must be installed on the wall or roof, it is necessary to use the relevant kit (op-
tional)
For assembly, follow the relative instructions, attached to the kit packaging, scrupulously.
f
. The unit must not be in a position that obstructs the passage of persons or animals.
g
. The unit should not be installed downwind of chimneys discharging burnt gas or subject to emissions of
fumes, oily or corrosive gasses.
h
. It should be possible to discharge the condensation produced.
i
. Take the air conditioner weight into account and select a place where noise and vibration will not be an
issue.
l
. Select a place so that the warm air and noise from the air conditioner do not disturb neighbors.
m
. Zones with probable accumulation of snow (figure 13).
Position the outdoor unit on a raised surface (wall), with height above the foreseeable maximum amount
of snowfall, since:
• if the appliance does not have a heat pump, when the snow melts, water may infiltrate inside the unit
and cause damage to the electric components.
• if the appliance has a heat pump, the accumulation of snow prevents the regular circulation of the air
and makes condensate drainage difficult.
n
. Positioning the unit on a floor area (terrace, land, roof, etc.) in areas that are difficult to access.
A Collection tray
B Piping compartment
C Electrician’s tape
D Connection pipe
E Connection cable
F Drain pipe