Olimpia splendid ALYAS E INVERTER 9, Инструкция по эксплуатации и техническому обслуживанию

Страница: 52 / 316

EN - 10
ENGLISH
Cooling Mode Heating Mode Dehumidification Mode
Room temperature 17°C - 32°C 0°C - 30°C 10°C - 32°C
External temperature
0°C - 50°C
-15°C - 30°C 0°C - 50°C
-15°C - 50°C *
* Models with low-temperature cooling systems
2.4 - SELECTION OF POSITION OF THE INSIDE UNIT
To obtain the best operating performance and prevent faults or hazardous conditions, the position of indoor
unit installation must meet the following requirements:
a . Do not expose the indoor unit to heat or steam.
b . Make sure that the space to the right and left is at least 120 mm and space above the unit is at least 150
mm. (figure 1).
c . The indoor unit must be installed at a minimum height of 2 metres and maximum of 3 metres from the
floor.
d . The wall where the indoor unit is to be fixed, must be stable, strong and suitable to support the weight.
e . There must be no obstacles for the free circulation of air both from the inlet side and especially the outlet
side. In particular, there must be no obstacles within a distance of 2000 mm.
A shorter distance could cause turbulence such to prevent correct operation of the appliance.
f . If possible, install the unit on an outdoor wall, in a way to be able to convey condensate draining to the
outside.
g . The indoor unit must not be in a position such that the air flow is aimed directly at the persons below
(figure 3).
h . The indoor unit must not be installed directly above household appliances (television, radio, refrigerator,
etc.) or above a heat source (figure 2).
i . Install the indoor unit in a way that there are no obstacles, which do not allow the signals emitted by the
remote control to be received (figure 4).
2.5 - INSTALLATION OF THE INSIDE UNIT
2.5.1 - Installation of fastening plate
After having checked that described in paragraph “2.2”, assemble the fixing plate (7) taking the dimensions
stated in figure X1 into consideration.
a . Position the plate against the wall.
b . Mark the drilling points, making sure that they are level.
c . Make the holes necessary in the wall using a suitable bit.
Make sure there are no pipes or electric ducts in the drilling area.
d
. Insert the plugs (4) into the holes and fix the plate (7) to the wall using the screws (3) supplied (figure 5).
Using a spirit level, make sure that the fixing plate (7) is level.
e
. If the wall is in wood, use relevant countersunk-head screws (not supplied).
f
. Check the stability of the plate (7), moving it laterally and vertically.
2.5.2 - Realisation of pipe passage holes
If the connection lines arrive from the rear right of the indoor unit, a hole “
R
” must be made for passage of
the piping, as successively described (see figure X1).