![background image](http://html1.mh-extra.com/html/oldham/sharpeye-np40igb/sharpeye-np40igb_user-manual_3710846025.webp)
26
Figure 6: Tilt Mount Assembly (dimensions in mm and inches)
Ø
To install the Tilt Mount and Detector:
9
Place the tilt mount in its designated location and secure it with four (4) fasteners through four
(4) holes 7 mm in diameter. Use the 4 screws and spring washers according to the kit (see
10
Table
15
and
11
Table
16
).
Note:
Removing the detector for maintenance purpose does not require the Tilt Mount
to be removed).
12
Unpack the detector.
13
Place the detector with its conduit/cable entries pointing downwards on the holding
plate of the tilt mount. Secure the detector with
5
/
16
" 18 UNC x ¾" screw to the tilt
mount.
14
Release the Horizontal and Vertical Locking Screws using
3
/
16
" Hex Key such that the
detector can be rotated. Point the detector towards the protected area and make certain
that the view of the area is unobstructed. Secure the detector in that position by
tightening the locking screws on the tilt mount. (Make sure the detector is in the
correct position.).
The detector is now correctly located, aligned and ready to be connected to the system.
Содержание SharpEye NP40IGB
Страница 1: ...Ref NP40IGB REV A Nov 2009 USER GUIDE...
Страница 35: ...36 Appendices...
Страница 49: ...50...
Страница 50: ...51...