1.2 IMPORTANT NOTES
Prior to using the Rover UC and its accessories, please read these operating instructions carefully.
These instructions give information on how to use the detector and potential sources where pre-
cautions should be taken.
The Rover UC and its accessories serve for the analysis, documentation and detection of sub-
surface anomalies and ground disturbances. The recorded data of the ground structure will be
transmitted to a computer to give a visual representation using our proprietary software program.
Any additional notes to the software should be observed. Please refer to the Visualizer 3D Studio
Documentation!
1.2.1 General Notes
Being an electronic device, the Rover UC has to be treated with caution and treated with care as
with any electronic device. Any failure to observe the safety precautions given or any use for pur-
poses other than the ones it is designed for may result in damage or destruction of the processing
unit and/or its accessories or connected components.
The device has a built in anti-tampering module which will destroy the unit if it is improperly
opened. There are no consumer serviceable parts inside the unit.
1.2.2 Possible Health Hazards
If used properly this device usually does not pose any health hazards. According to current scien-
tific knowledge, the high-frequency signals are not harmful to the human body on account of their
low power.
1.2.3 Surrounding Area
When moving this unit from a cold place to a warmer place, watch out for condensation. Do not
immediately operate the unit until any possible condensation could have evaporated. The unit is
not weather proof and water or condensation can destroy the unit.
Avoid strong magnetic fields, which may occur in places where there are large electric motors or
unshielded loudspeakers. Try to avoid using this equipment within 50 meters (150 ft) of this type
of equipment.
Metallic objects on the ground such as cans, tin, nails, screws or debris can influence your scan
data and present negative results regarding your scan data. Also it is a good habit to remove any
metallic objects off of your person like cellular telephones, keys, jewelry, etc. Do not wear steel
toe boots.
1.2.4 Voltage
The power supply can not be outside the indicated range of values. Use only approved chargers
which are included within the delivery scope.
1.2.5 Data Safety
Data errors can occur if:
•
the range of the sender module has been exceeded,
•
the power supply of the device or the batteries are too low,
•
the unit is operating to close to devices which sends out disturbances or
•
atmospheric conditions (electrical storms, lightning, etc.).
1.3 MAINTENANCE AND SERVICES
In this section you will learn how to maintain your measuring instrument with all included acces-
sories to keep it in good condition a long time and to get good measuring results.
The following list indicates what you absolutely should avoid:
•
penetrating water
•
strong dirt and dust deposits
•
hard impacts
•
strong magnetic fields
•
high and long lasting heat effect
To clean your device please use a clean and dry soft rag or cloth. To avoid any damage you should
transport the device and accessories always in an appropriate way.
Prior to using your Rover UC please be sure that all batteries are fully charged.
To charge the internal battery
use only the approved charger which are part of the delivery scope.
5 / 34
Содержание Rover UC
Страница 12: ...12 34 ASSEMBLY PREPARATION...
