![background image](http://html2.mh-extra.com/html/okidata/ol810e/ol810e_service-manual_3693744120.webp)
Page: 66
Service Guide OL810e
Chapter 6 Troubleshooting
6.5.1 LCD status message/problem list
The status and problems which may be displayed by messages on the LCD are listed in Table 6-1.
Category
LCD status message
Problem or status
Remedy
Controller
errors
An error occurred in the controller.
n = Exception Code aaaaaaa =
Error Address
Code(nn) Error
1 ~ 3 Reserved
D ~ F Reserved
4 Address Error Exception (Load
command, command fetch)
5 Address Error Exception (Store
command)
6 Bus Error Exception
(Command fetch)
7 Bus Error Exception (Load
command, store command)
8 System Call Extension
9 Break Point Exception
A Reserved Instruction Exception
B Coprocessor Unusable
Exception
C Arithmetic Overflow Exception
Normal operation cannot
be ensured. off, then
back on to restart.
If normal operation is not
recovered procedure,
replace the main control
board.
A checksum error occurred when
a card was inserted.
Turn the power off, then
back on
If a card other than
those for OL series is
being inserted, no error is
displayed and the
inserted card is ignored.
Содержание OL810e
