![background image](http://html2.mh-extra.com/html/okidata/ol810e/ol810e_service-manual_3693744024.webp)
Page: 11
Service Guide OL810e
Chapter 2 Operation Description
2.2 Power Supply/Sensor Boar
The power supply/sensor board consists of an AC filter circuit, a low voltage power supply circuit, a high
voltage power supply circuit, heater drive circuit, and photosensors.
(1) Low Voltage Power Supply Circuit
This circuit generates the following voltages.
Output voltage
Use
+5 V
Logic circuit supply voltage
+30 V
Motor and fan drive voltage and source voltage for high-voltage supply
+8 V
RS-232C line voltage
+8 V
RS-232C line voltage and PS board supply voltage
+3.3V
LED head supply voltage
(2) High Voltage Power Supply Circuit
This circuit generates the following voltages required for electrophotographic process from +5 V,
according to the control sequence from the main control board. When cover open state is detected, +5 V
supply is interrupted automatically to stop the supply of all high-voltage outputs.
Output
Voltage
Use
Remarks
CH
-1.35 KV
Voltage applied to charging roller
DB
-300 V/+300 V
Voltage applied to developing roller
SB
-450 V/ 0 V
Voltage applied to toner supply roller
TR
+500 V to +4 KV/-750 V Voltage applied to transfer roller Variable
CB
+400 V
Voltage applied to clearing roller
(3) Photosensor
The photosensor mounted on this power supply/sensor board monitors the status of paper being fed
through the printer during printing.
The sensor layout diagram is shown in Figure 2-2.
Содержание OL810e
