![background image](http://html2.mh-extra.com/html/okidata/ol810e/ol810e_service-manual_3693744197.webp)
Page: 114
Service Guide OL810e
Chapter D Diagnostic Tests
1.4 User Factory Set Operation
- Switching of ODA, OEL, and Non-Europe users settings is possible through the user factory set
operation.
- The user factory set operation is performed by turning the power on while keeping both the MENU
key and the or key pressed down.
(1) ODA Factory Set Operation:
Turn the power on while keeping the MENU key and key press down.
(2) OEL Factory Set Operation:
Turn the power on while keeping the MENU key and key pressed down.
(3) Non-Europe Factory Set Operation
- For Non-Europe 1 (Australia, etc.), turn the power on while keeping the MENU key and
FORM FEED key pressed down.
- For Non-Europe 2 (Singapore, etc.), turn the power on while keeping the MENU key and PRINT
MENU key pressed down.
- After executing the user factory set operation, set the EEPROM areas which are for other than the
engine block, to the factory default values.
Note: At the time of shipment from the factory, settings corresponding to the destination are mode at
the factory.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Содержание OL810e
