Oki ML3390, Руководство пользователя

Страница: 198 / 349

Chapter 14: Epson - Standard Function
14-16
There is a Form Feed to the start of the next page (Top of Form).
The parameter »n« designates the lines to be skipped to the start of
the next page. The lower margin actually to be skipped depends on
the current line spacing. Subsequent changes of line spacing have
no effect on the bottom margin to be skipped. All line feed com-
mands which place the print position in the area to be skipped cau-
se a jump to the start of the next page.
If Skip over Perforation is set at Yes in the printer menu, a bottom
area of one inch (2.54 cm) is skipped to the next Top of Form. The
number of lines to be skipped can be selected with the above Skip
command. The command ESC O switches off the »Skip Over Perfo-
ration« function.
The commands for setting page length similarly switch off Skip
over Perforation. The value for the function »Skip Over Perforati-
on« selected as menu item is activated.
If page formatting is taken over by the software, e.g. a word proces-
sing program, you should switch off Skip over Perforation by set-
ting Skip over Perforation in the printer menu to No.
Function Dec. Hex. ASCII
Set left margin 27 108 n 1B 6C n ESC l n
n = 0 to 255
Set right margin 27 81 n 1B 51 n ESC Q n
n = 1 to 255
In these commands the parameter n defines the left and right mar-
gins. The margin values are entered in character columns. The mar-
gin positions depend on the actual current pitch. Once the margins
are set the positions are retained even after changing the pitch, pro-
vided the margins have not been expressly reset (absolute positi-
on).
Note that the value for the right margin must be at least 1 inch lar-
ger than the left margin by the number of character columns given
in the table. The right margin must not exceed the maximum values
given below.
Set margins
Margins should always be set
at the start of a line.