Oki ML3390, Руководство пользователя

Страница: 216 / 349

Chapter 14: Epson - Standard Function
14-34
Ht = integer (TP in basic step sizes / 256)
Lt = TP in basic step sizes - (Hp * 256)
Hb = integer (page length - BP in basic step sizes / 256)
Lb = page length - BP in basic step sizes - (Hp * 256)
Valid values for the basic step size are: 1/360, 1/180, 1/120, 1/90,
1/72, and 1/60 inch.
With the top margin limit, measured from the top of page position,
is defined the top line of the printable area, with the parameter for
the bottom margin limit, the bottom line of the printable area mea-
sured from the top of page position.
In the case of single sheets, from the automatic cut sheet feeder or
the optional sheet guide, the areas of the top and bottom non-prin-
table area are defined as follows when the menu item Page Length
Control
is set to the value by Menu Setting:
0 inch < top area < bottom area < 22 inches.
If the areas are set to 0 inches or to values more than 22 inches, or
these areas are set to invalid values, this command is ignored.
With continuous paper and cut sheets by means of a cut sheet fee-
der, the areas of the top and bottom non-printable areas are defined
as follows if the menu position Page Length Control is set to by
Actual Page Length
:
0 inch < top area < bottom area < page length.
If the areas are set to 0 inches or to values beyond the page length or
these areas are set to invalid values, this command is ignored.
A set-up vertical format unit and set vertical tabs are not reset by
this command.
A defined print area is not affected if the basic step size is changed
later on.
If the printer is reset, the print area in the initial setting becomes
valid again.