Oki ML3390, Руководство пользователя

Страница: 52 / 349

Chapter 3: Paper handling
3-12
Do not forward paper to the
PARK position by using the
platen knob.
If continuous paper is being fed from the rear and you wish to
change to cut sheets, proceed as follows:
1. Part the already printed pages along the perforation.
2. In ON LINE mode, press the PARK button. The continuous pa-
per is transported backwards but remains held in the tractor
feed.
3. Move the paper lever on the right of the printer to the middle
position. The symbol for cut sheet handling (TOP) shows you
the correct lever position.
4. Raise the paper support.
5. Place a sheet of paper on the paper support. Adjust the paper
guide to the correct width. Start by aligning the left edge of the
paper to the mark provided.
6. The paper is automatically fed in after the time set in the menu.
If necessary, reset the top of form.
Should you wish to go back to continuous paper when you have
finished printing, proceed as follows:
1. Press the FF/LOAD button to eject the cut sheet still in the print-
er. Do not use the platen knob to do this otherwise you will lose
the top of form position you have set.
2. Move forwards the paper release lever on the right side of the
printer; the symbol for continuous paper (REAR) shows you the
correct position for the lever.
3. Press the FF/LOAD button again. The continuous paper previ-
ously removed from the paper path is drawn around the platen
again.
This function is also available when you use an automatic cut sheet
feeder (accessory).
Changing from
continuous paper to
cut sheets
Changing from
cut sheets to
continuous paper
Do not forward paper to the
PARK position by using the
platen knob.