Oki ES5112dn, Руководство по обслуживанию

Страница: 60 / 128

3-16
: Paper level indicator lever
: Driven roller
: Driving roller (Continuous rotation)
: Driving roller (Control rotation)
: Paper conveying route
: Indicating lever
: Photo sensor
: Micro switch
: Magnetic clutch
: Micro switch
Front
Back
Face up stacker
1st eject roller
2nd eject roller
Heat roller
Backup roller
Eject motor
(Pulse motor)
Feed roller
Feed roller
Pickup roller
Pickup roller
Tray (Pulse motor)
Conveying roller
Image drum
Main motor
(DC motor)
Conveying roller
Transfer roller
Registration roller
Registration roller
MPT feed roller
Multipurpose tray
MPT Pickup roller
Tray 1
Tray 2 (option)
3.1.6.4 Motor clutch test
This self-diagnostic menu is used to test the motor and clutch.
1. Enter the self-diagnostic mode (level 1), press the [MENU
] or
[MENU
]
key
repeatedly ,and press the [OK] key when the "MOTOR & CLUTCH TEST" is
displayed in the upper row of the display area. (Pressing the [MENU
]
key
increments the test item and pressing the [MENU
]
key decrements the test
item.)
2. Press either the [MENU
]
or [MENU
]
key until the desired menu item
corresponding to the unit to be tested in Table 3-4 is displayed in the lower row
of the display area. (Pressing the [MENU
] key increments the test item and
pressing the [MENU
]
key decrements the test item.)
MOTOR & CLUTCH TEST
ID MOTOR
3. Pressing the [OK] key starts the test. The unit name starts flashing and the
corresponding unit is activated for 10 seconds. (Refer to Figure 3-2.)
Note!
After the corresponding unit has activated for 10 seconds, it returns to the status of
step2, and is re-activated when the corresponding switch is pressed.
• The clutch solenoid repeats turning on and off during the normal print drive.
(If a clutch solenoid cannot be activated independently, the motor is driven at the
same time.)
• If [OK] key is pressed long (2 sec) when selecting a motor, the motor keeps
running.
4. When the [CANCEL] key is pressed, the corresponding unit stops activating.
(Display of the corresponding unit keeps displayed.)
5. Repeat steps 2 to 4 as required.
6. Pressing the [ ] key terminates the test. (Returns to the status of step 1.)
Figure 3-2
Table 3-4
Unit name display Drive restriction condition Remarks
MAIN MOTOR - -
EXIT MOTOR FWD FaceUp Cover close -
EXIT MOTOR REV FaceUp Cover open -
REGIST CLUTCH MAIN MOTOR driving -
T1 HOP CLUTCH MAIN MOTOR driving -
MPT HOP CLUTCH MAIN MOTOR driving -
T2 HOP CLUTCH TRAY2 MOTOR driving OPTION
T2 REGIST CLUTCH TRAY2 MOTOR driving OPTION
LV FAN TEST - -
FUSER FAN TEST - -
ID FAN TEST - -
Note! : The rollers that rotate continuously (each of heat rollers, image drums, and
conveying rollers) run in synchronization with the main motor.
3. ADJUSTMENT