3-2
3. ADJUSTMENT
•Maintenance mode includes the following.
- "Admin Menu" and "Boot Menu" which is shown by an end user.
- "Service Menu" , "System Maintenance Menu" and "Engine Maintenance
Mode" for the member of maintenance that is not shown by an end user.
- "Factory Maintenance Menu" to use in production in a factory.
•To view each category, push the button of "MENU " and "MENU ". After the
screen displays the last category, the display returns to the first category.
If want the displayed function to be effective, push the "OK" button.
For terminating the mode that is in category displaying, push the key of "ON
LINE" and return to operation mode.
3.1.1 Admin Menu
An usual menu is similar, and Admin Menu enters a menu by pushing
"Menu
△
" or "MENU
▽
" button from a Ready state and selects "ADMIN
MENU".
Enters a password is necessary for "ADMIN MENU".
The default value of password is "aaaaaa".
Except an item about emulation / interface, show a function in the following.
Category
Item
Value
Default
Function / Notes
ADMIN
SETUP
PANEL
SETUP
NEARLIFE STATUS
ENABLE
DISABLE
*
Sets up LED display control
for the occurrence of a near
life warning of a drum.
A near life warning is
displayed when Enable is
set.
A near life warning is not
displayed when Disable is
set. (It is also not output to
any of Attention LED/PJL/
MIB/Web.)
A status (life warning)
of temporal recovery by
opening and closing the
cover in a life error state is
not included.
3.1 Category and function of maintenance mode
Category
Item
Value
Default
Function / Notes
ADMIN
SETUP
PANEL
SETUP
NEARLIFE LED
ENABLE
DISABLE
*
Sets up LED lighting control
for the occurrence of a near
life warning of a toner or
drum
Attention LED is lighted
when Enable is set.*
Attention LED is not lighted
when Disable is set.
The status (life warning)
of temporal recovery by
opening and closing the
cover in a life error state is
not included.
* It applies to drums
when "PANEL SETUP" -
"NEARLIFE STATUS" is set
to "ENABLE".
It always applies to toner
regardless of the setting
of "PANEL SETUP" -
"NEARLIFE STATUS".
POWER
SETUP
AUTO PW OFF
ENABLE
AUTO CONFIG
DISABLE
*
Set the behavior of Auto
Power Off.
ENABLE: The printer goes
to Off mode even if LAN
cable is connected.
AUTO CONFIG: The
printer does not go to Off
mode when LAN cable is
connected, goes to Off
mode when USB or Centro
cable is connected.
DISABLE: Invalidate to go
to Off mode by time.
POWER RETURN
MANUAL
STATE CONTINUE
*
Set the power on method
after energize.
TRAY
SETUP
UNIT OF MEASURE
INCH
MILLIMETER
*L
*A
Specifies the unit of custom
paper size.
DEFAULT PAPERSIZE
A4
LETTER
*A
*L
Set default paper size.
