Oilon RE 35, Инструкция по установке и эксплуатации

Страница: 11 / 72

RE01 1445EN 9 (67)
2. Installation
2.1. Installation site requirements
Installation, commissioning or service of equipment must be
carried out by authorized personnel only, adhering to all local
regulations and requirements.
General site requirements
When installing the heat pump, note the following recommendations and requirements:
● The installation site must have a floor drain.
● Site temperature must be between 10 °C – 40 °C.
● Install the heat pump on an even surface and make sure it is horizontal. You can
adjust the level with the housing screws on the bottom of the heat pump.
● Make sure the flooring is able to withstand its weight.
● Make sure that the heat pump does not touch any wall.
● The heat pump is covered against moisture and water.
● The installation site should ideally be separate from the common living area so that
it is easier to contain noise.
Space requirements
All heat pump connections are at the back of the device and with flexible hoses they
can be bent to desired directions. Always use flexible hoses when connecting the pump
to piping to retain the warranty. For installation, operating and maintenance purposes,
leave enough space on each side of the heat pump. The minimum space requirements
are presented in the following.