Oilon ESi 6-17, Инструкция по установке и эксплуатации

Страница: 43 / 80

To access additional settings, tap on the cogwheel button.
Available settings
Setting Description Available options Factory default
Extra heat resistor amount The number of
supplementary heaters
1–4 1
Heating time before extra
heat
Delay before the first
supplementary heater is
switched on
10 min
Time between extra heat
starts
The delay after the first
supplementary heater is
switched on. Once the
delay has elapsed, the next
heater will be switched on.
15 min
Change resistor control Changing the control
method for supplementary
heaters
Analog or Digital Digital
Analog control
(only if the control method
is Analog)
Control signal values
for switching on each
supplementary heater
(power stage).
0–10 V.
There are 4 different
power stages,
one for each
supplementary
heater.
0, 0, 0, 0
Locations of additional heat
sources
Upper storage tank
and lower storage
tank
Upper storage tank
4.6.7 Compressor rotation (optional)
The compressor rotation accessory can be used only when all of the
heat pumps in the system feature the ÄssäControl system.
The compressor rotation function automatically evens out the working hours of the
compressors in the system. Each compressor will run for a specific time, after which
the next compressor in the start order will start.
The
Compressor rotation
view allows you to specify a Start interval and Stop interval
for compressor rotation. The Start interval determines how long each heat pump will
run in their own turn before it is stopped. The Stop interval is the delay before the next
heat pump in the start order will start after the previous has stopped.
4.7 Cooling (optional)
The ground source heating system can be equipped with optional cooling solutions.
There are two primary types of cooling available: free cooling and flexible cooling.
Basic cooling options can be accessed through the Other settings menu (menu button
→Other settings →Cooling). Advanced cooling options can be accessed through the
Maintenance menu
(menu button → Maintenance menu → Cooling).
M8010 2204EN 41 (75)