- 28 -
9-5
Screws tend to pass through
the passing plate in an
abnormal position.
The axis of the screw thread
tends to enter the passing plate.
・
Adjust the passing plate.
・
Reduce the quantity of screws to
a proper level.
9-6
No screw comes to the
pick up site.
・
Screws are stopped while still on
the rail.
・
Screws cannot be transferred
smoothly from the rail to the
escaper.
・
The passing plate is not adjusted
properly.
・
Too many screws are in the
scooping chamber.
・
Adjust the position of the holding
plate.
・
Adjust the distance between the
end of the rail and the escaper or
adjust the height of the
escaper.
9-7
The machine stops its
operation suddenly.
・
The overload protective circuit was
activated.
・
Too many screws are in the
scooping chamber.
・
A screw is caught in the clearance.
・
A Screw, at the pick up site,
could not be picked up for an
amount of time.
・
Turn the machine OFF and then
ON again.
・
Remove the cause of overload.
・
Remove screws to a proper level.
・
When the machine stops, even if
the screws are at a proper level,
consult our service section.
・
Remove the screw that is caught.
・
Remove the screw.
Trouble
Cause
Corrective measures
