OHTAKE NSRI Series, Руководство по эксплуатации

Страница: 9 / 36

- 8 -
５ -
４
．
Checking and adjusting the passing plate
・
Check that the passing plate is adjusted to a height that permits
loaded screws to pass just within the clearance limit.
・
If the passing plate is too low, screws cannot pass. If the passing plate
is too high, it will hamper a smooth transport of the screws.
・ If adjustment is required, loosen the passing plate attaching bolt
and adjust the height.
・
After making an adjustment, do an operational check.
Note: Using the half-presses on both sides of the passing plate as
guides, slide the passing plate up or down.
５ -
５
．
Checking and adjusting the rail vibration
This machine’s rail vibration can be adjusted.
The screw transport speed differs depending on the screw type.
Check the screw transport speed. If the rail vibration hinders a smooth
transport of the screws, it can be adjusted.
・
Loosen the anti-vibration screw at the rear of the machine.
Next, turn the vibration adjusting screw, located on the bottom of the
machine, to adjust the vibration.
When the screw is turned clockwise, as viewed from the bottom
of the machine, the vibration will increase.
When the screw is turned counterclockwise,
the vibration decreases.
・
If the vibration is adjusted to a too large a value to increase the
transport speed, the rail will hit against the escaper and screws may
fall into the machine from the clearance, failing to unload screws
normally. Adjust the vibration to a proper value that matches the
loaded screws.
(Related item: Check and adjust the front and rear positions of the rail.)
・
After making an adjustment, be sure to tighten the vibration plate fixing bolt.
・
After making an adjustment, do an operational check.
Passing plate
Loaded screw
Passing plate
attaching bolt
Half-press
(provided on both sides of
the passing plate)
The clearance should be just enough to permit the loaded screws to
pass through the passing plate.
W e a k e r
vibration
Vibration adjusting plate
fixing bolt
V i b r a t i o n
a d j u s t i n g
bolt
The rail must not come in contact with the escaper.
The clearance must not be too large.
Turn OFF the power switch before making any checks or
adjustments.
S t r o n g e r
vibration