OHAUS Navigator Series, Руководство по обслуживанию

Страница: 43 / 52

APPENDIX C SOFTWARE SERVICE TOOL INSTRUCTIONS
Navigator Series Service Manual 41 Ohaus Corporation www.ohaus.com
APPENDIX C. SERVICE TOOL
The Software Service Tool (Part Number 83032124) is required when a main PC Board is replaced in
a Navigator scale. It is used to re-configure the scale to its original parameters in the case of a PCB
replacement.
Note: NVHD models are separated from NV general models in service tool, since the configuration
and software are both different.
The latest software service tool and support files are available on the Ohaus DMX site.
Tools to connect the scale with computer
1. RS233 Interface Kit
– PN 83032107 (USB Interface Kit – PN 83032108 is not fit for software
upgrade)
C.1 HARDWARE AND SOFTWARE SETUP
1.
First, check that the scale’s
A-Off feature, under the SETUP menu, is set to OFF .
If this setting is left ON, the scale will shut off during configuration.
2. Install the RS232 Interface Kit into the scale. Follow the instructions in the RS232 Interface Kit
User Manual.
3.
Plug the cable into the PC’s RS232 or the USB port, which need another cable PN 30304101
(RS232 - USB).
4. Install the software on the PC.
5. Download the Service Software ZIP file from the Ohaus DMX Navigator (New) directory.
6. Place the Zip file in its own directory on the PC, un-Zip the file.
7. Run the program Service Tool with the version V2.3.0.0 or later.
8. Go to Repair Tool NAVIGATOR, you will see the Function Interface.