OHAUS Courier 7000, Инструкция по эксплуатации

Страница: 19 / 63

Courier 7000 EN-15
3.5.4 Weight Alert
This application is used to judge if the weight of the item is within the target limit. There are 2 limit values for
setting, the limit 1 is normally open as default.
Setting the Limit Values
1. Long press the Mode button until
ALERt
appears on the display.
2. Release the Mode button, the
CLr.ALe
appears on the display.
3. Press
Yes
button to remove the stored alert limit value, and
LImM.1
appears on the display.
4. Press Yes button,
000000
is flashing on the display with the current unit.
5. To set the limit value 1, you can do the steps that follow:
a) Use the buttons NO and Back to set a number for the first digit.
b) Short press the Yes button to confirm the number and move to the next digit.
c) Repeat the steps a) and b) to set numbers for all the digits.
d) Press
Yes button to confirm the value. If the value is not in the correct range, the
NO
appears on the
display. You must repeat the steps 3, 4 and 5 to set the value. If the value is in the correct range, the
LImM.2
appears on the display.
NOTE : If the
LImM.2
is set to off, the
LImM.2
will not appear on the display and the scale goes into
the weighing status directly.
6. Repeat steps 4 and 5 to set the limit value 2. If the value is not in the correct range,
NO
appears on the
display. If the value is in the correct range, the scale goes into the weighing status.
NOTE :
1. You can check the limit values by short pressing the Function key.
2. You can set either or both of the limit values. If the weight value of the load is larger than either limit value,
the segment text and the backlight blinks at the same time. Thus, the load is not acceptable.
If the weight value of the load is larger than both the limit values, the segment text blinks. Thus, the load is
not acceptable.
The maximum limit value is not larger than the capacity value.