OHAUS Courier 7000, Инструкция по эксплуатации

Страница: 24 / 63

EN-20 Courier 7000
4.2.6 Calibration Test
[
C.test
]
Calibration test procedures:
1. Long press the Menu button until you see
mM.E.N.U
.
2. Release the button and wait for the display to show
C.A.L
. Press the Yes button.
3. Short press the No button several times to navigate until you see
C.test
. Press the Yes button.
4.
0
and the calibration unit are flashing on the display based on the capacity and unit you set in the setup
menu. With no weight on the platform, press the Yes button to establish the zero point.
5. The display shows
--C--
while the zero point is recorded.
6. The calibration weight and the unit of the last time are flashing on the display. (For example,
015.000
kg).
6. To change the test calibration weight, you can do the steps below.
a) Short press the No button several times until the desired number appears.
NOTE : press the Back button can decrease the digit.
b) Short press the Yes button to accept the number and move on to the next digit.
c) Repeat the process until all the digits are correct.
d) Press the Yes button to accept the calibration point. It is flashing on the display.
7. Place the specified test weight on the platform and press the Yes button.
8. The difference between the calibration data and the test weight is flashing on the display. (For example,
0.010
kg). If the terminal is connected to a printer or other devices, the result will be printed.
NOTE : the printed result will appear as below:
Example:
--------- Cal Test ---------
New Cal:15.000kg
Old Cal:15.000kg
Diff Cal:0.0000kg
Wt. ID:_____________
------------ End -----------
9. After 5 seconds, the test ends and the scale returns to the active weighing mode, displaying the current
weight.
4.2.7 End Cal [End]
When
End
is displayed, you can press the Yes button to exit this menu and enter the next sub-menu, or press
the No button to enter to the first menu item in this sub-menu.
4.3 Setup Menu
You can set the scale parameters with the menu
S.E.t.u.P
. Default settings are in bold .
Menu Sub-Menu
Sub-Menu (in
segment)
Options Options (in segment)
Setup
S.E.t.u.P
Reset reset no , yes
NO, yes
Capacity Unit
C.UNIt
kg , lb
/
Capacity CAP 1-99999.9
/
Graduation Grad 0.0001~100
/
Power On Zero
P.ZerO
Off, On Off , ON
Power On Unit
P.UNIt
Auto , g, kg, lb, oz, lb:oz
AUtO
Auto Tare
A.tare
Off , On Off , ON
End
End
/ /
NOTE : / indicates that it is not applicable in the table above.
Reset [
reset
]
Reset the Setup menu to factory defaults.
NO
= do not reset
yes
= reset
Capacity Unit [ C.
UNIt
]
Select the unit used for calibration.
kg
lb