EN-6 BW SERIES COMPACT BENCH SCALE
4.
OPERATIONS
4.1 Turning the Unit On and Off
Wth the scale off, press
ON/OFF
to turn on. Make sure the weghng pan s empty
before turnng the scale on. Allow 15-30 mnutes for the scale to warm up before
use. Wth the scale on, long-press
ON/OFF
to turn off.
4.2 Manual Tare
Place a contaner on the weghng pan, then press
TARE
. The dsplay wll show
a net value of “0” as the Tare weght s regstered. Remove the contaner, and the
resultng negatve value dsplayed wll be equvalent to the Tare weght. To clear the
Tare value, press
TARE
wth the pan empty.
4.3 Zero Operation
Press
ZERO
to zero the stable weght dsplay (the weght must be wthn ±2% of
scale capacty). Center of Zero s ndcated by the LED annuncator.
4.4 Checkweigh Target Setting
Compares the weght of an tem aganst a pre-set Over-Under range.
To actvate Checkweghng Mode, refer to user setup (Secton 5.2).
• Press
CHECK
to ntate enterng Over-Under parameters.
• The value of the “OVER” target lmt wll be dsplayed frst, wth the actve
dgt flashng (the “OVER” LED annuncator s lt).
• Enter the desred “OVER” lmt value by pressng
TARE 0 9 t
o ncrement
the actve dgt or
CHECK
to shft to the next dgt.
• Press
ON/OFF
to accept the dsplayed value and proceed to the “UNDER”
target lmt (the “UNDER” LED annuncator s lt).
• Enter the desred “UNDER” lmt value by pressng
TARE 0 9
to ncrement
the actve dgt or
CHECK
to shft to the next dgt.
• Press
ZERO
to accept the dsplayed value and ext nto checkweghng
mode.
NOTES
:
• “OVER” or “UNDER” LED annuncators wll lght f the weght of an tem
placed on the pan s over or under the pre-set lmts, respectvely. “OVER”
and “UNDER” LED annuncators wll lght smultaneously f the weght s
wthn the pre-set lmts.
