50
MENUS
Lockswitch
Lockswitch enables you to lock out one or more menu selections. Each menu can be
individually locked on or off
after all functions have been set. The Calibration, User,
Setup and Print menus can be individually locked on or off by selecting the appropriate
menu and then locked by the switch located under the front of the control panel. See Menu
Lockout Section. Cal Test under Calibration remains functional with the Lockswitch On or
Off. Before performing the lockout procedure, decide which functions of the balance are to
be locked on or off.
1. Access the
submenu which is under the Setup menu.
2.
MODE
to access either Calibration, User, Setup or Print menus.
3.
ON
TARE
to access selected desired menu.
4.
MODE
to select
or
.
YES = locked, NO = not locked.
5.
ON
TARE
to accept.
6.
MODE
to change to other menus.
7. To change other menus, repeat steps 2 through 5.
List
This submenu can be used to output a listing of current menu settings via the RS232
interface. When selected, all menu settings for the User, Setup and Print menus will be
output either to an external printer or computer. To use this feature, your balance must be
connected to a computer or printer.
1. Access the
submenu under the Setup or Print menus.
2.
ON
TARE
. The display indicates a
series of dots traveling right to left when the balance is sending information.
Exit Setup Menu
1.
MODE
.
NOTE: If any Setup parameter is different from previous settings, indicator SETUP in the
display flashes while the balance is storing new settings. Proceed with next step.
2.
ON
TARE
.
SETUP
locs_ı
yes
NO
l IsT
l IsT
. . . . . . .
eND
seTup
Menu
Menu
