20
OPERATION
Fill Guide (Cont.)
Reference Number
If reference number was selected under the Fill Option submenu with the balance in a
weighing mode, proceed as follows:
1.
ON
TARE
.
2.
ON
TARE
. Set the flashing digit to the desired weight value.
3.
MODE
until the first digit is correctly displayed.
4.
ON
TARE
to accept the digit.
5. Repeat steps 3 and 4 until all digits are set. When the last digit is entered , the balance
is automatically in the fill mode.
6. The fill mode can now be used by placing samples on the pan. If the sample weight
equals the reference weight, the bar graph indicates 100%, the weight is displayed.
7.
ON
TARE
to exit the fill option mode.
8.
MODE
, the balance is now in a weighing mode.
High Point
High Point is
enabled only when High Point Function is selected under the Setup menu.
Refer to page 38. High point is a feature which permits a number of samples to be weighed
with the balance
storing the lowest sample weight and the highest sample weight. The
samples which are in between the low and high points are disregarded and not displayed.
NOTE: When using this function, the balance does not respond to weights below 100 digits.
With the balance in a weighing mode, proceed as follows:
1.
ON
TARE
, LIMIT is dis played,
indicating the function is on.
2. Place the first sample on the balance pan. When the balance has stabilized, the weight
is displayed. Remove the weight.
3. Place a second sample on the pan. After the balance stabilizes, the second sample
weight is displayed if it is greater than the first sample. This procedure can be continued
with a number of samples. The highest weight sample is always displayed.
seT Ref
00000.00
g
0.00000
s
g
seT Ref
0.00
s
g
hi pT
LIMIT
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
I
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
I
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
I
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
I
Menu
Menu
