OGSI MOGS - 100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 67

Effective 11/2010 26
Although every
MOGS-100 unit is thoroughly tested and checked before it is
shipped from our facility, the following checks are necessary to ensure that none of
the internal components have been damaged in shipment. This check should take
less than five minutes to perform.
(Refer to ‘ Initial Inspection’
on Page 2 before
reading the instructions below)
Make a visual inspection of the interior and exterior of the machine. Ensure that all
parts are properly attached and that there is no obvious damage including external
manifold (if applicable).
Connect the unit to an electrical panel of 230 VAC with a 30 A circuit breaker.
Ensure that the touch screen is powered and a display is visible. Consult the
troubleshooting guide in this manual (
See Page 28 ) for any problems encountered.
After entering a password and selecting a language, start the machine by pressing both
the
Operating Mode (AUTOMATIC) , and then the ON/OFF buttons.
Listen for the sound of the compressors and cooling fan to start running, if you do not
hear them within a few seconds, shut the machine down immediately by pressing the
ON/OFF button and call OGSI for assistance.
Once the machine is running, press the MAIN MENU button then press GAUGES to
view the GAUGE screen. Both the regulated air and low oxygen pressure gauge needle
indicators should be operating within the highlighted green area. The Oxygen Purity
Gauge should steadily increase to above
90%
.
The oxygen storage tank pressure gauge should indicate a pressure increase after
approximately
15 minutes . If this does not occur, check to make sure that none of
the hose connections have come loose . Call
OGSI Technical Service Department
at
(800) 414-6474 (toll free number in USA and Canada) or (716) 564-5165 if no loose
connections are found and trouble persists .
Set-up & Installation