Chapter 2 Installation
Chapter 2 Installation
Dangerous voltages capable of causing death are sometimes present in this instrument. Before installation
or beginning any cleaning or troubleshooting procedures the power to all equipment must be switched off and
isolated. Units suspected of being faulty must be disconnected and removed to a properly equipped workshop for
testing and repair. Component replacement and internal adjustments must be made by a qualified maintenance
person only.
Dangerous voltages capable of causing death are sometimes present in this instrument. Before installation
or beginning any cleaning or troubleshooting procedures the power to all equipment must be switched off and
isolated. Units suspected of being faulty must be disconnected and removed to a properly equipped workshop for
testing and repair. Component replacement and internal adjustments must be made by a qualified maintenance
person only.
Do not use this instrument in areas under hazardous conditions such as excessive shock, vibration, dirt,
moisture, corrosive gases or oil. The ambient temperature of the areas should not exceed the maximum rating
specified in Chapter 6.
Do not use this instrument in areas under hazardous conditions such as excessive shock, vibration, dirt,
moisture, corrosive gases or oil. The ambient temperature of the areas should not exceed the maximum rating
specified in Chapter 6.
2-2 Mounting
2-2 Mounting
2-1 Unpacking
2-1 Unpacking
Upon receipt of the shipment remove the unit from the carton and inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier. Write down the model number, serial number, and
date code for future reference when corresponding with our service center. The serial number (S/N) and date code
(D/C) are labeled on the box and the housing of control.
Upon receipt of the shipment remove the unit from the carton and inspect the unit for shipping damage.
If any damage due to transit , report and claim with the carrier. Write down the model number, serial number, and
date code for future reference when corresponding with our service center. The serial number (S/N) and date code
(D/C) are labeled on the box and the housing of control.
Make panel cutout to dimension shown in Figure 2.1.
Make panel cutout to dimension shown in Figure 2.1.
Take the mounting clamp away and insert the controller into panel cutout. Install the mounting clamp back.
Take the mounting clamp away and insert the controller into panel cutout. Install the mounting clamp back.
Remove stains from this instrument using a soft, dry cloth. Don't use harsh chemicals, volatile solvent such
as thinner or strong detergents to clean the instrument in order to avoid deformation or discoloration.
Remove stains from this instrument using a soft, dry cloth. Don't use harsh chemicals, volatile solvent such
as thinner or strong detergents to clean the instrument in order to avoid deformation or discoloration.
This instrument is protected throughout by
-- . To minimize the possibility of fire or shock
hazards, do not expose this instrument to rain or excessive moisture.
Double Insulation
This instrument is protected throughout by
-- . To minimize the possibility of fire or shock
hazards, do not expose this instrument to rain or excessive moisture.
Double Insulation
Figure 2.1 Mounting Dimensions
Figure 2.1 Mounting Dimensions
13
ETR-3000
(98.0mm)
Panel
(10.0mm)
(12.5mm)
SCREW
MOUNTING
CLAMP
(22.2mm)
(45mm)
7/8”
1 25/32”
31/64”
13/32”
3 7/8”