OCULUS Corvis ST, Инструкция по эксплуатации, Страница: 38 / 86

12 Perform a Mea s urement
32 / 80 Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
12.2 Adju s ting the Corvi s ® ST
Before starting a measurement, adjust the Corvis® ST.
Attention
Risk of contact of the patient's eye with the air nozzle

Before starting a measurement, make sure the safety stop is set
correctly,
sec. 10.5.2, page 21 . This prevents the air nozzle from
touching the patient's eye.
Danger of pinching to hands or body parts

During a measurement: Make sure that the patient does not put
either his hand or any other body part between the measure head
and adjusting base.
Note
Incorrect measurements from a dirty air nozzle

Before each measurement, check the glass part of the air nozzle from
a diagonal angle for dust, dirt, etc.

If necessary, clean the air nozzle “Clean the air nozzle (2)” page 57 .
12.2.1 Rough Adju s tment

Check that
 fresh paper has been put onto the chin rest or that the chin rest
has been cleaned.
 that the head rest has been cleaned and disinfect the head rest
after each examination,
sec. 15, page 55 .

Do not touch the Corvis® ST (including accessories) and the patient
simultaneously.