OCULUS Binoptometer 4P, Инструкция по эксплуатации

Страница: 48 / 60

13 Disposal
44 / 55 Instruction Manual Binoptometer® 4P (G/59860/1016/en)
13 Disposal
In accordance with Guideline 2012/19/EG of the European Parliament
and of the Council, and also the Law of the Federal Republic of Germany
on the Commercialization, Recall and Environmentally Compatible
Disposal of Electrical and Electronic Equipment, old electrical and
electronic equipment must be sent out for recycling and may not be
disposed in household trash.

Transport the Binoptometer® 4P in a compliant manner.
14 Troubleshooting
Caution
Risk of personal injury or equipment damage due to improper
troubleshooting

If an error occurs which you are unable to correct by following the
instructions below, label the device as "out-of-order" and contact
our service department or an authorized dealer.
Error Possible source Remedy
The Binoptometer® 4P program
doesn’t start after the On/Off
switch is pressed There is no power. Check that

the power cord is plugged in
correctly.

the power cord is not defec-
tive.

the netbook/laptop/PC is cor-
rectly connected.

the fuse is not defective. If so,
replace the fuse,
sec. 11.3.2, page 41 .
The following error message is
displayed: "Binoptometer® 4P
could not be found. Error code = -
1” The Binoptometer® 4P is not
properly connected to the netbook
/ laptop / PC. Check the connection from the
device to the netbook / laptop / PC.