OceanDMX RC
.
2021 INSTALL & OPERATION MANUAL
22
3.8 PARING THE REMOTE
Fit 3x AAA batteries to the remote (not supplied).
Pairing additional remote with DMX Receiver
STEP 1:
Connect and wire up the DMX Receiver
according to wiring diagram (Table 2), power on.
STEP 2:
Click
ON/OFF
button to activate the
remote
STEP 3:
C
lick the “Learn Switch” button on the
DMX controller, the LED light next to the learn
switch should light-up (see Figure 1 for details).
STEP 4:
Immediately touch the colour wheel. The
LED light next to the learn switch of the receiver
should flash on and off once, meaning the
receiver has paired with the zone successfully.
The learning mode lasts around 4 seconds so the
steps 3 - 4 must be done within this period of time.
Note:
Up to 8 remotes can be paired with one
DMX Receiver. Please follow the same procedure
for pairing with additional remote/s.
Delete the pairing (all stored remotes):
1. Wire up the DMX Receiver correctly, power on.
2.
Hold down the “
Learning Switch
” button on the DMX controller for over 3 seconds until the LED light next to the
button flash on and off twice, which means pairing deleted.
ON/OFF BUTTON
ZONE NUMBERS
COLOUR WHEEL
4.5V (3x AAA battery)
Bottom side
