Oceanic Proplus 4.0, Руководство по эксплуатации

Страница: 42 / 50

42
PROPLUS 4.0 OPERATING MANUAL
© Pelagic, 2019 Doc. No. 12-5669-r01 (1/18/19)
Inspection
• Activate the unit and watch carefully as it performs a full diagnostic and battery check, and enters Surface Mode. Observe the LCD display to
ensure it is consistently clear and sharp in contrast throughout the screen.
• If any portions of the display are missing or appear dim, or if a Low Battery Condition is indicated, return your ProPlus 4.0 to an Authorized Oce-
anic Dealer for a complete evaluation before attempting to use it.
ALTITUDE SENSING AND ADJUSTMENT
Altitude (i.e., ambient pressure) is measured upon activation and every 15 minutes until a dive is made.
• Measurements are only taken when the unit is dry.
• Two readings are taken, the second reading 5 seconds after the first. The readings must be within 1 foot (30 cm) of each other to record that
ambient pressure as the current Altitude.
• No adjustments are made during any time that the Wet Contacts are bridged.
• When diving in high altitude waters from 3,001 to 14,000 feet (916 to 4,270 meters), the ProPlus 4.0 automatically adjusts to these conditions
providingcorrected Depth, and reduced No Deco and O2 Times at intervals of 1,000 feet (305 meters).
• When the Conservative Factor is set On, NDLs are calculated based upon the next higher 3,000 foot (915 meter) Altitude.
• At Sea Level, calculations are based upon an Altitude of 6,000 feet.
• All adjustments for Altitudes greater than 11,000 feet (3,355 meters) are then made to allowable dive times for 14,000 feet (4,270 meters).
• The ProPlus 4.0 will not function as a Dive Computer above 14,000 feet (4,270 meters).