MNL-1024 Rev A
8
Installation
Overview
You must install the operating software application prior to connecting a Flame-NIR+ spectrometer to the computer. The Ocean
Insight spectrometer operating software installs the drivers required for the spectrometer installation. If you do not install the
software first, the system will not properly recognize the spectrometer.
If you have already connected the Flame-NIR+ to the computer prior to installing the operating software, consult Troubleshooting for
information on correcting a corrupt installation.
1.
Install the spectrometer operating software on the destination computer.
2.
Locate the Micro USB cable provided.
3.
Insert the small end of the cable into the Flame-NIR+.
4.
Insert the rectangular end of the cable into the USB port of the PC.
If you installed the spectrometer operating software prior to connecting the Flame-NIR+, the software installs the Flame-NIR+ drivers.
Once you install the software and hardware, and establish your sampling system, you are ready to take measurements.
Hardware Features
Flame-NIR+ LEDs
The Flame-NIR+ features two indicator lights that operate as shown below:
LED
Steady
Flashing
Red
Unit is on
N/A
Green
Unit is ready
Unit is acquiring data
NOTE
LEDs can be turned off in OceanView or by using a firmware command.
Содержание FLAME-NIR+
Страница 2: ......
Страница 21: ...MNL 1024 Rev A 18 Mechanical Diagram Dimensions in inches mm...