Oce Arizona 640 GT, Руководство пользователя

Страница: 74 / 230

Using Vacuum Zones - Metric Zones
Introduction
The overlay sheet on the printer table creates a vacuum field, which is divided into zones by
magnetic strips on the underside. When the printer is shipped, the vacuum zones are configured
to support common metric or imperial media sizes . The zones are installed at the factory,
according to operator preference when the printer is ordered. The purpose of the vacuum zones
is to reduce the preprint setup time by reducing the need to mask the open area on the vacuum
table when printing on the most common size media. The printer ships with a vacuum field
configured to support either metric or imperial size media.
For the Océ Arizona 600 Series GT vacuum control valve handles are used to manage these
zones. The printer has five control valves that determine the zones that are active when the table
vacuum pump is on. Zone 1 area is always active, and the five valves control zones 2 through 6.
The vacuum zones are open when the valve handles are vertical.
NOTE
The Océ Arizona 600 Series XT vacuum zones are described in Chapter 6.
Purpose
The vacuum system holds the media in place. The zones described in this section are arranged to
accommodate common media dimensions.
Metric Vacuum Zones
The following shows the locations and media dimensions associated with the factory-set metric
vacuum zones. The name of the zone indicates which vacuum handle controls that zone (except 1
as that zone is always on).
• Vacuum zone 1 = 600 x 800 mm
• Vacuum zone 2 = 700 x 1000 mm
• Vacuum zone 3 = 800 x 1200 mm
• Vacuum zone 4 = 1000 x 1400 mm
• Vacuum zone 5 = 1000 x 2100mm
• Vacuum zone 6 = 1250 x 2500mm
The metric configuration is designed such that zone 6 can be reconfigured by a service
representative from the 2.5m x 1.25m area size to 4'x8'.
Using Vacuum Zones - Metric Zones
74 Chapter 5 - How to Operate Your Océ Arizona Printer
Océ Arizona 600 Series