Oce Arizona 640 GT, Руководство пользователя, Страница: 69 / 230

Select Print Icon, Print Mode, and Confirm Media Thickness
When you select the Print toolbar icon it will gray-out the icon and the hand icon to the left of the
job to be printed will turn green.
When printing Flatbed mode and Flatbed icon on the command toolbar is not selected, select it.
Similarly, if printing in roll mode and the Roll icon is not selected select it.
The print job's icon should change to red/orange, and also the Pause icon and Confirm thickness
buttons should appear in the command toolbar right beside Media thickness field.
Enter the measured media thickness value in indicated measurement units.
Select the 'Confirm thickness' button.
Prepare Media for Printing
Place And Register Media On The Printer Vacuum Table
Place the media on the table in the orientation that matches the job to printed and register the
media to the print origin. In the next section there are more details on how to perform the
following actions.
Select Active Vacuum Zones
Select the required vacuum zones to hold the media to the table using the table vacuum. The
three vacuum zone control handles control which of the three zones on the printer table will have
vacuum applied when the table vacuum pump is turned on. The vacuum zones are opened or
closed using a quarter turn handle. Refer to the next section for details on the dimensions and
placement of the vacuum zones.
Turn On Table Vacuum
Click on the Vacuum button in the top right corner of the printer software display to activate the
table vacuum. Also a vacuum foot pedal switch is provided to help secure the media on the table
vacuum. Step on the foot pedal to toggle the table vacuum on or off.
Mask Active Vacuum Zones Not Covered With Media
To hold the media to the table it is important to completely cover active vacuum zones with either
the media to be printed on, or a masking material. The masking material should not be thicker
than the media to be printed on. If a full bleed image is to be printed, the masking material should
be the same thickness as the media to be printed on to prevent overspray from accumulating on
the print head nozzle plates.
NOTE
When the vacuum is switched off, wait a few seconds before you switch it on again.
Clean Media, If Required
If the media is dusty or dirty, clean it with an appropriate cleaner. If using a liquid like isopropyl
alcohol, allow sufficient time to dry prior to imaging.
Start Print
The Print button is located at the corner of the table where media is loaded. Press the Print button
to start the print job. If the job was selected, the media thickness confirmed and the vacuum is
turned on, printing will start after the ink and lamps reach operating temperature.
How to Set Up a Print Job
Chapter 5 - How to Operate Your Océ Arizona Printer 69
Océ Arizona 600 Series