Oce 31x5E, Руководство по настройке и обслуживанию

Страница: 14 / 156

14 Océ 31x5E Configuration and special maintenance
Accessing the key operator system
The key operator system is used to perform management and maintenance
tasks. The key operator system can be accessed at the operating panel and from
a PC, if the Océ 31x5E is equipped with the optional Print Logic software.
Settings related to the copier can only be defined at the operating panel.
The key operator functions are restricted to a specific user, and therefore a PIN
code is required at the operating panel or when you access Print Logic. At
installation, the service technician configures the key operator PIN code. This
means that only the service technician can change it.
After performing key operator activities, make sure you quit the key operator
system to prevent improper use of the Océ 31x5E. Any changes you make in
the settings will only be applied after you have quit the key operator system.
Note:
If the machine has an error for which you need to call the service
technician, you can still use the key operator mode to access information by
pressing 1 and 0 at the same time.
Some settings can be made on both the operating panel and Print Logic. In this
manual you will find two procedures for each task (where applicable). This
facilitates your work, as some settings can be made directly from the desktop
of your PC instead of having to access the operating panel at the Océ 31x5E.
▼
▼ ▼
▼
Accessing the key operator system using the operating panel
1
Open the ‘Extra’ section and select ‘Special settings’ with the card selection
button.
2
Press the ‘System management’ function button to select ‘Key Operator’.
3
Press start ( ) to confirm.