OBI 402494, Оригинальная инструкция по эксплуатации

Страница: 44 / 178

44
GB
Figure 14 – Page 7
– Mount the wind sensor, as shown, at an appropri-
ate distance to the awning.
Setting the wind sensor
Figure 15 – Page 7
– Remove the cover.
– Undo the fixing screw (A).
– Align the wind sensor and tighten the fixing
screw.
Electric drive
Laying cables
Connecting the motor
Figure 17 – Page 7
– Connect the devices as shown.
Connecting the wind sensor
Figure 17 – Page 7
– Connect the devices as shown.
Changing the remote control batteries
– Open the battery compartment on the rear of the
remote control.
– Remove the old batteries.
Insert new batteries and close the battery compart-
ment.
Teaching the remote control
If the motor cannot be controlled with the remote con-
trol even though the batteries are fully charged, tune
it into the motor. To do this, disconnect the motor from
the power for at least 10 seconds, plug it in and
quickly press the following buttons:
Figure 1 – Page 3
– Press buttons (13) and (14) 2x simultaneously
– Press button (13)
Operation
Remote control
Figure 1 – Page 3
– Use the remote control in accordance with the
specifications detailed in the figure.
Hand crank
The hand crank is used only to retract or extend the
awning in the event of a power failure or when either
the switch or remote control is defective.
Setting the end position switch
– Used the included tool for settings.
DANGER! Risk of electric shock! The
electrical installation may only be carried
out by a professional electrician taking
account of the current legal requirements
(VDE 100) as well as national and regional
requirements.
The enclosed installation instructions for
the supplied electrical units must be
observed.
Note:
The battery is not included in the
scope of delivery. Use only CR 2450 but-
ton cells!
Note: Operating the motor!
In the event of overheating caused by fre-
quent use, the thermal protection function
may switch the motor of the awning off. In
this case, you should wait approximately
20 minutes until you operate the awning
again. Otherwise there is a risk of lasting
damages for which no guarantee can be
made. This thermal protection function
acts to ensure the long life of the awning.
CAUTION! Risk of damage to the
device!
If the end switches are not cor-
rectly set, there is a risk that the motor will
run hot. This may lead to motor damages
and, potentially, cause a risk of fire.
CAUTION! Risk of damage to the
device!
To set the motor using the upper
and lower setting screws please do not
use any electrically-powered screw fixing
devices (e.g. a cordless screwdriver); only
turn screws manually - even if that takes
some time. The setting is very sensitive.
Please only turn the screw a half-turn each
time and then check the corresponding
stop point. A full turn corresponds to
approximately 2.5 cm more/less travel. If
the setting screws are overtightened this
will cause a defect in the motor electronics
that we can detect and will result in refusal
of any warranty claims.
402494_Markise_elek.book Seite 44 Mittwoch, 15. November 2017 10:54 10