19
TROUBLESHOOTING [TO BE PERFORMED BY STORE PERSONNEL] - PAGE 1 of 2
Product is Drying Out
Check the relative humidity in the store.
Water on the Floor
Caution!
Water on flooring can cause much damage! Until cause is
determined (and unit repaired), follow these procedures:
Use wet-dry vacuum (or mop & bucket) to remove standing water.
Use ‘catch pans’ for water to drain into. Swap out regularly until case has
completely drained.
Check store conditions.
To prevent condensation in Type 1 environments, maximum conditions are
to be 55% humidity / 75° Fahrenheit.
For Type 2 environments, maximum conditions are to be 60% humidity /
80° Fahrenheit.
See serial label (at case rear near main power switch) for Type of case.
If unable to resolve issue of water on floor, contact technical service. Call
toll-free number listed at end of manual.
Excessive Fan Noise
Check that the case is aligned, level and plumb.
System is not Operating
Check that the utility power is on.
Check that the MAIN power switch is on.
Check the circuit breaker box for tripped circuits.
Digital Control Display
is Blank
Check that the MAIN power switch is on.
Check the circuit breaker box for tripped circuits.
Fans Not Working
Check that the MAIN power switch is on.
Check that the case is aligned, level and plumb.
Case Lights Not
Working
Check that light is properly installation.
Check bulb for proper connection.
Check for burned out bulb.
Clean dirt and dust from the bulb to prevent flickering.
Check that light switch is in the
on
position.