7. Other meter functions
Automatic shut-off mode
If no key is pressed during a 20 minute period, the meter automatically shuts off to
conserve power. To restart the 20 minute count, turn the meter on again.
To disengage the automatic shut-off mode for a given power-on cycle:
17
16
7.1
1.
Press OFF.
2.
Press Mn/Mx and ON simultaneously
and hold until the screen displays
“nSL”, indicating that it is in the non-
sleep mode. Release the keys.
See figure
NOTE:
To switch back to the automatic
shut-off mode, press OFF then ON.
The meter will enter automatic
shut-off mode each time you turn it
on unless you perform the above
steps to disengage this feature.
Q
T
T
4.
Press PRG
to save the value for
this alarm set point. The screen
displays “SA” then the current value
for the set point.
See figure
5.
To reset another alarm set point, repeat
steps 2 through 4. Otherwise, press RST
to return to the measurement mode.
To cancel an alarm setting:
1.
In the alarm set mode, select the alarm
set point you wish to cancel.
i) In the measurement mode, press PRG.
ii) Select the alarm set point you wish to
change.
a) Press NEXT, if necessary, until the
code (Lo Temp, Hi Temp, Lo %RH,
or Hi %RH) corresponding to the set
point you wish to change is flashing.
b) Press PRG. The screen displays the
set point you selected to change,
such as “Lo Temp”, and the current
value for this alarm set point.
2.
Press NEXT and release. Press the RST
key and hold for two seconds.
A beep
sounds when you press the key, and two
more beeps sound after two seconds.
Release the key.
See figure
3.
Press RST
to return to measurement
mode.
To cancel all four alarm settings at once:
1.
Press OFF.
2.
Press RST and ON simultaneously
and hold until the screen displays
“OAL” and two beeps sound.
See figure
3.
Release the keys. All alarm settings
are now cancelled and you are in the
measurement mode.
S
S
F
LOTEMP
HITEMP
LO%RH
HI%RH
R
R
Q
