Setting alarm set points
This mode lets you set, change, or cancel the values of the four alarm settings.
NOTE:
If the meter reads a value above a high set point or below a low set point,
the alarm beeps and the screen displays the code for the exceeded set point.
14
15
Set the alarm points as follows:
1.
In the measurement mode, press PRG.
2.
Select the alarm set point to change.
i) Press NEXT, if necessary, until the
code (Lo Temp, Hi Temp, Lo %RH, or
Hi %RH) corresponding to the set
point you wish to change is flashing.
See figure
ii) Press PRG. The screen displays the
set point you selected to change, and
the current value for the set point.
See figure
3.
Reset the value for this alarm set point.
i) For lo/high temperature alarms only
[start at step ii) for humidity]:
• 0 to 199.9°F: If you are entering a
temperature value in °F and do not
have the correct number of digits
shown for your new value, press
Mn/Mx
briefly to place or remove a
“1” in the one-hundreds position of
the old value.
• –17.7 to 93.2°C: If you are entering
a temperature value in °C, press
Mn/Mx
to place or remove a “–”
sign in front of the old value.
ii) Press NEXT, if necessary, one or
more times until the digit you need
to change is flashing.
See figure
iii) Press Mn/Mx until the flashing
number is the number you need.
See figure
iv) Repeat steps 3 (ii) and 3 (iii), if
necessary, until all digits are correct-
ly set to the new set point value.
6.2
6. Alarms
Viewing alarm set points
This mode lets you check the current values of the four alarm settings.
The following codes correspond to the alarm set points:
• Lo Temp: low temperature alarm set point
• Hi Temp: high temperature alarm set point
• Lo %RH: low relative humidity alarm set point
• Hi %RH: high relative humidity alarm set point
Check the current alarm set point values as follows:
6.1
F
LOTEMP
HITEMP
LO%RH
HI%RH
K
F
LOTEMP
HITEMP
LO%RH
HI%RH
L
L
F
LOTEMP
M
M
1.
In the measuring mode, press PRG.
The screen displays “Lo Temp, Hi
Temp, Lo %RH, Hi %RH” and the
current alarm set point value for
Lo Temp. “Lo Temp” will flash.
If no alarm is set, the screen will
display “----”.
See figure
2.
Press NEXT repeatedly
to scroll
through the Hi Temp, Lo %RH, and Hi
%RH alarm set point values.
3.
When finished, press RST to return to
the measuring mode.
F
LOTEMP
N
N
F
LOTEMP
P
O
K
