O-TL VFF23NLM, Руководство владельца по эксплуатации и установке

Страница: 10 / 30

Figure 5 - Minimum Clearance for
Combustible to Wall
MINIMUM CLEARANCE TO
COMBUSTIBLE MATERIALS
Top 36”, Left and Right Sides 6”,
Bottom and Rear 0”, Front 36”
*Minimum 16” from Side Wall
INSTALLATION
Continued
NOTlCE: Surface temperatures of
adjacent walls and mantels become
hot during operation. Walls and
mantels above the fi rebox may
become hot to the touch. If installed
properly, these temperatures meet
the requirement of the national
product standard. Follow minimum
clearances shown in this manual.
1. ManteI must be installed fl ush with wall
Base board must be altered or removed
for mantel installation.
2. Place hearth base against wall at instaI-
lation Iocation. Cut an access hole in
hearth base to run gas line to fi replace
fsee Figure 6). Make sure to locate access
hole to inside of mantel.
Note: You can secure base to fl oor using
wood screws. Counter sink screw heads
and putty over.
3. Route fl exible gas line through access
hole in hearth base.
WARNING: Do not allow any
combustible or noncombustible
materials to overlap the fi rebox front
facing.
WARNING: Never modify or
cover the Iouvered slots on the front
of the fi rebox.
WARNING: Do not allow non-
combustible materials to cover any
necessary openings like Iouvered
slots.
Figure 6 - Locating Gas Shutoff Valve
10
FIREPLACE SYSTEM lNSTALLATION
Follow these instructions for system installa-
tion. Refer to instructions on page 6 for hood
assembly.
CAUTION: Two gas line
installations at the same time are
forbidden. Do not open or access
the selector valve while heater is
operating.
GAS SELECTION
Heater is preset at the factory for propane/
LP gas. No changes are required for con-
necting fi replace to a propane/LP gas
supply. Only a qualifi ed installer or service
technician can perform gas selection and
connecting to gas supply.
For Propane/LP Gas
1. Mark on rating label propane/LP gas.
2. No other actions needed.