nVent.com
|
19
Standard factory settings are shown
bold
.
Non-standard factory settings:
Chapter 1.5 “Type-dependent factory settings”
Parameter display independent of the controller type:
Chapter 7.2 “Controller”
Decimal places for some parameters depend on the device
setting:
Chapter 7.8 “Display/Operation/Service counter”
7.
Configuration level
Normal display
>2s
or timeout
Navigation principle
one level
backward
one level
forward
next/previous
parameter
F
EXIT
F
EXIT
Levels can be inhibited.
Chapter 4.4 “Defining various user levels”
TIP!
Parameters are not displayed unless the equipment level permits
the function assigned to the parameter. This means, for example,
that interface parameters can only be configured, if the device is
equipped with an interface.
TIP!
Some parameters can only be programmed through the Setup
program. In the following tables, these are marked in the
“Parameters” column with “(Setup)”.
TIP!
Standard factory settings are displayed
bold
in the following
tables in the “Value/Selection” and “Description” columns.
Non-standard factory settings are shown in Chapter 1.5
“Type-dependent factory settings”.
TIP!
For activation of binary input 2 the setup program is required
(Hardware assistant).
Configuration level
ConF
- Analog input
inP
- Controller
Cntr
- Ramp function
rAFC
- Limit comparators
LC
- Timer
tFCt
- Outputs
OutP
- Binary functions
b
,nF
- Display
d
,SP
- Interface
intF
PArA
ConF
OPr/USEr
1
1.
Either the Operator
(
OPr
)
or
the User level
(
USEr
)
exists
Содержание 1244-0006829
Страница 1: ...TCONTROL CONT 03 COMPACT MICROPROCESSOR CONTROLLER OPERATING AND INSTALLATION MANUAL...
Страница 2: ......
Страница 46: ...46 nVent com...
Страница 47: ...nVent com 47...