30
OSD Menu Terms & Settings
6.3 DELAY TIME
(05-99)
This function is used to set the delay between switching of the modes. If the delay has
been set to ‘5,’ the camera will observe darkness for at least 5 seconds before switching
to Night mode.
6.4 DAY
a
NIGHT
(1-8)
This level determines the threshold level of the darkness before switching from Day
mode to Night mode.
Note:
The selectable threshold for the “NIGHT
a
DAY” conversion changes depending
on the level set for the “DAY
a
NIGHT” conversion. (i.e. If “DAY
a
NIGHT” is set to 2,
“NIGHT
a
DAY” selectable threshold would be only from 3-9, instead of full 2-9 range)
6.5 NIGHT
a
DAY
(2-9)
This level determines the threshold level of the brightness before switching from Night
mode to Day mode.
6.6 IR LED SETUP (Models equipped with IR LEDs only)
This function is used to adjust the intensity of the IR LED. Too much IR reflection from a
subject causes over-exposure on the most focused area causing ‘Hot Spots’ within the
picture. Adjusting this setting can help avoid such problems.
