Nuvair 8060, Руководство пользователя, Страница: 9 / 40

Open Vertical Electric
9
www.nuvair.com
1.7 Proper Compressor Use

Improper use could have serious consequences for the user.

Use the compressor in areas free from dust, risk of explosion, corrosion and fire.

Do not disconnect the hose from the fittings or the clamp when under pressure.

Change the air purification filters regularly as described in the Maintenance section.

Drain the condensate regularly as illustrated in section “Condensate discharge”.

Never pull an electrical plug out by tugging the lead. Make sure the lead is not bent at
a sharp angle and that it does not rub against any sharp edges. Use of extensions is
not advised.

Never operate the compressor when:

the power lead is damaged

there is evident damage

All routine and unscheduled maintenance tasks must be carried out with the
compressor at a standstill, the electrical power supply disconnected or locked out and
all lines are depressurized.

After switching off the compressor wait about 30 minutes before carrying out any
maintenance tasks so as to prevent burns.

The high pressure flex hose that connects to the bottle (also called the refill hose)
must be in good condition, especially in the areas near the fittings. The plastic sheath
that covers the hose must not show any signs of abrasion otherwise moisture could
get in and corrode the steel braid thus weakening it. The hose must be changed
periodically (yearly) or when it shows signs of wear. Failure to observe this rule could
seriously endanger the users’ safety. Make sure the minimum bending radius of the
hose is no less than 250 mm (1 inch).
To ensure maximum working efficiency,
Nuvair has constructed the compressor with carefully
selected components and materials. The compressor is tested prior to delivery. Continued
compressor efficiency over time will also depend on proper use and maintenance as per the
instructions contained in this manual.
All the components, connections and controls used in its construction have been designed and built
to a high degree of safety so as to resist abnormal strain or in any case a strain greater than that
indicated in the manual. Materials are of the finest quality; their introduction and storage in the
company and their utilization in the workshop are controlled constantly so as to prevent any damage,
deterioration or malfunction.