TWO POST SPL10000
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
| us.nussbaumlifts.com
8
OPERATING INSTRUCTIONS
READ ALL OWNER’S MANUAL INSTRUCTIONS AND ANSI/ALI ALOIM
BEFORE USING THE LIFT
TO LOAD VEHICLE
Clear
persons and objects from Lift working area.
Pull Down the Manual Release Lever AND the Lowering Lever to
lower the Lift Carry Arms to the lowest position.
Swing the
Lift Carry Arms out.
Drive the vehicle into the middle of the Lift area.
Secure the
vehicle from rolling, put into gear, and apply the hand brake.
Swing the
Lift Carry Arms under the vehicle and position the Lift Adapter Pads
at the Lift points specified by the vehicle-manufacturer.
The manufacturer’s service garage Lift points may be marked on the
undercarriage of the vehicle with triangle shaped markings. If the Lift
points are not marked on the vehicle, refer to the vehicle manufacturer
for the approved Lift points.
The Center of Gravity must be located slightly towards the Long Lift
Carry Arms.
Determine the
center of gravity. If necessary, adjust the Lift Adapter Pads to assure equal contact with the Lift
Carry Arms and the vehicle.
Check all the
danger points of the Lift to ensure that loose objects or people are clear from Lift and working area.
Modified or specialty vehicles: Contact vehicle manufacturer to
determine if vehicle can be lifted on a frame engaging Lift.
Lift
Carry
Arm
Содержание SPL 10 Series
Страница 1: ......
