TWO POST SPL10000
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
| us.nussbaumlifts.com
9
TO LIFT VEHICLE
Press and Hold the
Raise Button.
Allow the
Lift Carry Arms to raise up close to the underside of the vehicle without coming
into contact.
Release the
Raise Button to stop the Lift and check to ensure the Arm Restraint Pins are
engaged. If
the Arm Restraint Pins are not engaged, move the Lift Carry Arm to allow the
Pawl and Restraint Gear to engage properly.
DO NOT hammer the pin into place. Damage to the restraint gear
teeth will occur.
Once the
Arm Restraint Pins are engaged properly, press the Raise Button again.
Allow the
Lift Carry Arms to connect with and lift the vehicle.
Continue raising the
vehicle until the wheels have cleared the floor by approximately 6”.
Verify that the
Arm Restraint Locks have dropped into position.
Verify the
vehicle is properly centered on the Lift and all pads are properly positioned on the
manufacture approved Lift points of the vehicle.
Closely observe how the vehicle is positioned on the Lifting Pads.
The vehicle may fall from the Lift if all four Lifting Pads are not in
full contact with the vehicle at the manufacturer’s recommended
Lift points.
Raise the
vehicle to the required working height only if vehicle is stable on the Lift.
Always observe the complete lifting and lowering process.
Engage the Manual Lock Lever and then pull down the Lowering Lever till you here a clicking noise. This would
engage the locks and hold the lift at this position securely. Avoid rocking the vehicle while it is on the lift.
Use safety stands (not included) for added protection when removing
or installing heavy components.
TO LIFT PICKUP TRUCKS
Special care must be taken when lifting pickup trucks or other vehicles with truck frames!
Ensure that the
frame has not been weakened by corrosion and/or modifications.
Check the trucks
center of gravity.
Confirm that the
truck’s individual axle weighs are less than half of the total Lift allowance.
TO LOWER AND UNLOAD VEHICLE
Check all the
danger points of the Lift to ensure that loose objects and people are clear from Lift and working area.
To disengage Lock Mechanisms, Press and Hold the
Lift Button to raise the Lift slightly.
Push both the
Lock Release Lever and the Lower Lever at the same time.
Lower the
Lift to the required working height.
Always observe the complete lifting and lowering process.
Disengage the
vehicle from the Lift Adapter Pads by lowering the Lift Carry Arms to their lowest positon.
Swing the
Lift Carry Arms out from underneath the vehicle.
Raise
Button
Содержание SPL 10 Series
Страница 1: ......
