TWO POST SPL10000
Nussbaum Automotive Solutions, LP | 1932 Jordache Court, Gastonia, NC 28052 | 704.864.2470 | Email:
| us.nussbaumlifts.com
25
LIFT CARRY ARMS INSTALLATION
Remove Swivel Arm Pin from Yoke.
Grease Swivel Arm Pin and Holes.
Install the
two Short Lift Carry Arms on the “motor side” of the Lift.
It is best to use the shortest arm length as possible while ensuring
proper connection at the manufacturers designated “pick-up” points.
For each Lift Carry Arm: Slide
Lift Carry Arm into Yoke and install Swivel Arm Pin.
Attach the
second C-Clip at the bottom of the Pin to secure into place.
Repeat with all
Lift Carry Arms.
Raise and lower the
Lift several times without load.
Check
Synchronizing Equalizing Cable for proper tension by pinching the cables
together between your fingers just below the carriage. The cables should
barely touch together for proper cables tension. (Adjust the tension as
needed.)
To Seat\level both Lift Carry Arms in the
Locks, Press and Hold only the Lift Button.
Place the Hydraulic Cylinder Protection Cover on both Posts.
Secure with provided
Bolts.
Place the
Overhead Telescope Cover in place and secure.
Содержание SPL 10 Series
Страница 1: ......
