Nussbaum POWER LIFT HF 7000, Руководство по эксплуатации и книга учета инспекций

Страница: 32 / 76

32 OPI-POWER LIFT HF 7000-8000-V1.0-EN
Time frame
Position
Type of
maintenance
Person in
charge
Maintenance plan
Annually
1
12
11
10
9
8
7 6 5
4
3
2
1 x / 12
Trained ser-
vice personnel
Check the paint:
• Check the powder coating and improve if required.
Damage by external influences is to be treated im -
mediately after detection. If these points are not
treated, infiltration of deposits of all kinds can cause
wide-ranging and permanent damage.
These points are to be lightly sanded (120 grit),
cleaned and degreased. Afterwards, rework with a
suitable touch up paint (note the RAL No.).
• Check galvanised surfaces, touch up as needed.
White rust is fostered by permanent humidity, poor
ventilation. The affected areas can be treated by
using a sanding cloth (A 280 grit). If required, the
parts are to be treated with a suitable, resistant ma-
terial (paint etc.). Check the RAL colour selection.
• Rust is brought out by mechanical damage, wear,
aggressive deposits (de-icing salt, leaking operating
fluids) cleaning that is not done or incomplete.
The affected areas can be treated by using a sand-
ing cloth (A 280 grit). If required, post-treat the areas
with a resistant material (paint etc.).
Annually
1
12
11
10
9
8
7 6 5
4
3
2
1 x / 12
Trained ser-
vice personnel
According to manufacturer instructions, the hydrau-
lic oil should be changed every two years in normal
operations. Various environmental influences e.g. lo -
cation, temperature swings, intensive operation etc.,
can have an influence on the quality of the hydraulic
oil. For this reason, the oil must be checked during an-
nual safety inspections and maintenance.
The oil is used if it has a milky colour or if the hydraulic
oil smells unpleasantly.
To change oil, lower the lift is to its lowest position then
suction the oil out of the oil container and replace the
contents.
The manufacturer recommends high-quality clean hy-
draulic oil. The required oil volume and type is to be
taken from the technical data. After filling, the hydrau -
lic oil must be between the upper and lower marking
on the oil dipstick, or approx. 2.5 cm below the oil fill -
ing opening.
Dispose of the old oil according to regulations to the
intended location (district offices, environmental pro -
tection office or commercial regulatory office has the
obligation to disclose about disposal points).