Nussbaum JUMBO NT 3500, Инструкция по эксплуатации и документация

Страница: 23 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 23
-
5. Operating instructions
The Safety Regulations must be observed during working with the automotive lift.
Read the safety regulations in chapter 4 carefully before working with the lift!
5.1 Lifting the vehicle
• Drive vehicle over the lift, longitudinal axes on line of the lift.
• Before drive on the platform. Lower the ramp until the rolls are lying on the floor.
Otherwise, the ramps and supports can be damaged.
• Block the vehicle against rolling, put into gear.
• Position elastomer-supports under the pick-up points of the vehicle as prescribed by the
vehicle-manufacturer.
If necessary use the ramps for the safe position of the vehicle. If the wheelbase is too
short and the wheels are standing on the ramps, remove the ramps.
The vehicle must be positioned on the elastomer supports in a safe way, otherwise
there’s a danger that the vehicle might fall down.
• Switch on the control system; main switch on position ”1” (see pic.1)
• Check the dangerous places of the lift and be sure that there are no objects or people in
the immediate area of the lift or on the lift.
• Lift vehicle until the wheels are free. Press button ”lifting”. Check that the vehicle is safety
positioned.
• Lift the vehicle on the working height. Press the button „lifting“ .
• Observe the complete process.
Pic 1: Operating unit
1 main switch
2 button „lifting“
3 button „lowering“