Nussbaum JUMBO NT 3500, Инструкция по эксплуатации и документация

Страница: 35 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 35
-
Lower the lift into the lowest position.
• Then close N1 & N2. A1 & A2 are still open.
Pic.
Position X = the bore holes at the back for the equalisation screws
The holes in front are for the emergency lowering screws.
• Raise the lift on approx. 1000mm. Check the position of the locking device. The locking
device must not shows upwards. (pic).
• Lower the lift a few centimeter. Press shortly the button „lowering“. After it raise the lift
completely to the top end position.
Bleeding the slave cylinder FO1 und FO2:
• Open alternately slightly at both cylinder FO1 & FO2 the vent screw (pic 3) . Not unscrew
completely!
Close the vent screw if only oil comes out. Close the screws guardedly. Otherwise the
threaded can damaged.
pic 3:
Pos. X = Bleeding screws at the slave cylinder
Locking device