Nussbaum JUMBO NT 3500, Инструкция по эксплуатации и документация

Страница: 33 / 48

Operating Instruction and Documentation
Jumbo NT 3500
- 33
-
• Raise the lift on a height of approx. 1500mm.
• Check the position of the base plates again before doweling. Adjust first one base plate, than
adjust the second base plate. If there is an uneven floor even it out with washers. A
continuous contact between floor and base plate must be guaranteed to avoid hollow
spaces.
• Dowel the lift on the floor.
• Before doweling check the concrete floor with quality min.C20/25 if the concrete floor goes to
the top edge of the floor. In this case the dowels have to be chosen according to pic. 10. If
the ground is covered with floor tiles, the dowels have to be chosen according to pic. 11
It is important for the trouble free working that the base plate are clean and the guides of the
sliding block are clean and greased.
• Bore holes to fix the dowels through the borings of the base plate. Clean the holes with
pressure air. Put in the dowels.
Nussbaum Company recommended safety dowels from different manufacturers (Liebig, Hilti,
Fischer or us equivalent dowels of other manufacturer but observe the regulations.
• Dowel the lift on the ground.
• Tighten the dowels with the dynamometric key.
Each dowel must be tightened with the demanded torque. Otherwise the normal function of
the lift can not guaranteed.
Observe the regulations of the other dowel-manufacturer.
• Raise and lower the lift several times with load. Check the torque of the dowels and check
the hydraulic parts for tightness.
• If necessary equalize the lift again.
• Mount the covers.
• Dowel the foot protection on the floor. Lower the lift in the lowest position. Position the
protection. The distance between the platform and the protection is approx. 10 mm. The
protection must not touch the platform.
Oil filler