Nussbaum HL2150.034-7016, Руководство по эксплуатации

Страница: 37 / 80

OPI-POWER LIFT HDL 15000 - HDL 18000-V1.0-EN 37
4 Installation
The installation of the Lift is performed by manufactur-
er trained technicians or by the manufacturer’s distri-
bution partner. The Lift owner may use their trained
mechanics to install the Lift. The installation must be
performed according to the following regulations:
• Use architectural plans, if available, to determine
Lift location.
• Lift is intended for indoor installation only. Installa-
tion in an outdoor application is prohibited and will
void the warranties of the product.
• Always consult a qualified person regarding local
regulations for seismic requirements. The owner has
to consult a qualified person to address any local
or state requirements (per the ALCTV standard: “a
qualified person should be consulted to address
any seismic loads and other local or state require-
ments”)
• Do not install Lift in hazardous locations, pit or de-
pression areas, or washing stalls.
• Concrete must have compression strength (see
chapter 8).
• Mount on a foundation deeper than the local ex -
ternal frost line.
• Be sure to read the ANSI/ALI ALIS prior to installation.
• The installer has to return the instructional materials
furnished with the lift back to the owner.
Shiping / parts list
POS ITEM NAMES ITEM CODES QUANTITY LOCATION
1 COLUMN MASTER WITH LIFTING
CARRIAGE AND LIFTING ARMS 1 BOX
2 COLUMN SLAVE WITH LIFTING
CARRIAGE AND LIFTING ARMS 1 BOX
3 RISER 232SL05070 2 BOX
4 TRANSVERSE TUBE 1 BOX
5 COVER 265HDL01032 2 BOX
6 MEASURING HOSE 500 MM 982048 1 BOX
7 LOCKING PIN 250HDL48119 4 BOX
8 SCREW PACKAGE PLASTIC BAG
CYLINDER SCREWS M6 X 12 10 PLASTIC BAG
NUT 6,4 - 9021ST ZN 10 PLASTIC BAG
9 MANUAL 975497 1 BOX
5 Operating manual
When handling the lift, it must abso-
lutely comply with safety regulations.
Carefully read the safety regulations
in Section 4 before first operation!
5.1 Lifting the vehicle
• Drive the vehicle into the middle of the lift length-
wise.
• Secure the vehicle against rolling away. Apply
the handbrake, put into gear.
• To swivel the lifting arm inwards, the “unlock” but-
ton must be pushed on the operating unit. This
opens the pneumatic interlock.
Swing in the lifting arms and place the adjust-
able receiving plate at the vehicle manufacturer
specified points. As soon as the lift is raised, the
lifting arm is interlocked.
• Consider the total centre of mass, this must be as
close as possible to the middle of the lift.
Depending on the vehicle type, it may be re-
quired to raise the receiving plate so that the ve-
hicle is horizontal in a raised state.
Figure 1
• Inspect the hazardous area. No person or object
may stand in the working area of the lift, or on the
lift.