Nussbaum HL2150.034-7016, Руководство по эксплуатации

Страница: 48 / 80

48 OPI-POWER LIFT HDL 15000 - HDL 18000-V1.0-EN
Time frame Position
Type of
maintenance
Person in
charge
Maintenance plan
Annually
1
12
11
10
9
8
7 6 5
4
3
2
1 x / 12
Trained ser-
vice personnel
According to manufacturer instructions, the hydraulic
oil should be changed every two years in normal op-
erations. Various environmental influences e.g. loca -
tion, temperature swings, intensive operation etc, can
have an influence on the quality of the hydraulic oil.
For this reason, the oil must be checked during annual
safety inspections and maintenance.
The oil is used if it has a milky colour or if the hydraulic
oil smells unpleasantly.
To change oil, lower the lift is to its lowest position then
suction the oil out of the oil container and replace the
contents.
The manufacturer recommends high-quality clean
hydraulic oil. The required oil volume and type is to
be taken from the technical data. After filling (18), the
hydraulic oil must be between the upper and lower
marking on the oil dipstick, or approx. 2 cm below the
oil filling opening. Dispose of the old oil according to
regulations to the intended location (district offices,
environmental protection office or commercial regu -
latory office has the obligation to disclose about dis -
posal points).